Culligan Mark 100 Instruções de Operação descarregar pdf (Página 22)

20 CULLIGAN

MARK 100 WATER SOFTENER

The service check mode allows one to view the instantaneous flow rate, the days since the last regeneration,

the total number of regenerations, the regenerations in the past fourteen days, and the gallons remaining.

To enter the service check mode, follow these steps:

Service Check

1. Press the status key to move past steps 1-10 until

the display is blank.

2. Push the down arrow. The number '12' will

appear only when the Soft-Minder

meter is

connected. The display reads the gallons per

minute flow rate. This screen will update with

the current meter reading every 6 seconds.

3. Press the down arrow. The number '13' and an

"A" will light at the bottom of the display. The

display will indicate the number of regenerations

that have occurred in the last 14 days.

5. Press the down arrow. The number '14' will light

at the bottom of the display. The number in the

display indicates the number of days since last

regeneration.

6. Press the down arrow. The number '15' will be

displayed if the flow meter or Aqua-Sensor

connected. For the controls with the Soft-

Minder

meter, the display indicates the gallons

remaining before the unit signals for regeneration

(multiply the displayed number by 10). For

Aqua-Sensor

controls, the number indicates the

total minutes of the last brine rinse cycle.

4. Press the down arrow. The number '13' and a 'B'

will light at the bottom of the display. The

display will indicate the total number of regen-

erations this control has cycled through.

NOTICE: Pushing the up arrow at any of these displays will immediately bring you to the control position

display, the number '11' will light at the bottom of the display.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Sem comentários

Culligan Mark 100 Instruções de Operação Página 22